How To Use ECU Cover Open Tool Bosch ECU Cover Extractor Open And Close ECU Cover

ECU Cover Open Tool is New ECU Opening Tool Wor Together with ecu chip tuning tool. Bosch ECU Cover Extractor Minimum quantity purchased 4 or 6 pieces to be able to work. Need ECU Cover Open Tool User Manual? Below OBD2Tuner.net sharing How To Use ECU Cover Open Tool Bosch ECU Cover Extractor Open And Close ECU Cover:

ECU Opening Tool Bosch ECU Cover Extractor Car Computer Remover Tool ECU Cover Open Tool

How To Use obd2tuner.net ECU Cover Open Tool Bosch ECU Cover Extractor open the ECU:

1. Remove all screws the hold the ECU together using the torque screwdriver.



2. If required apply the heat gun to the perimeter of the ECU to heat the glue that secures the lid (Red Line).

Be careful not to overheat the case or the plastic connector block!




3. Carefully use a flat headed screw driver to prise the ECU open starting from the position shown below.



4. Use the blade to cut through the sealant holding the ECU lid to the case.



5. Using the two flat headed screw drivers, work your way along the top edge using the blade to cut through the sealant as you go along.



6. Once the top edge has been fully separated. Repeat the same process on the near edge, ensuring again that you penetrate the ECU by no more than 7mm.



7. Once the top and near edges have been separated, then using the flat headed screw drive, prise the ECU lid away from the connection block as shown below.



8. The bottom edge has been left until last due to the large amount of sealant applied to the flat bevel section of the ECU. With three of the four edges now released, use your hands to prise away the lid from the remaining edge.

Be sure to apply firm steady pressure and not strenuous short bursts.



9. With the final remaining sealant, lift the ECU case lid and run the blade along the edge separating the ECU lid completely from the ECU.



10. Before carrying out any further work, inspect the ECU board for any visual damage and reconnect to the car with case reattached to ensure the vehicle still starts.



How To Use obd2tuner.net ECU opening tool Bosch ECU Cover Extractor Closing the ECU

1. After you have finished loading the software into the ECU. Take the thermal paste and apply to the section demonstrated below. The thermal paste helps dissipate heat away from the ECU board.



2. Apply a thin bead of sealant around the metal exterior rim of the ECU

3. Place the ECU lid back on to the ECU and screw down all screws. Once sealed ensure all edges are closed and any excess sealant wiped away.



4. Reconnect the ECU to the vehicle and ensure it starts.


For More details information, welcome to Add my Whatsapp (+86 15889512468) or Skype obd2tuner.com) if you have, Your Private Secretary in Car Repair Area! 16 Hours Online at your Service!

www.OBD2Tuner.Net--China OBD2 Tuner Tool Automotive Diagnostic Tools Car Key Programmer OBD2 ECU chip tuning tool Center.

Contacts:

Website: www.obd2tuner.net
Skype: OBD2Tuner.com
Email: info@obd2tuner.com
What;s app: +86 15889512468